Axia Analog Node Bedienungsanleitung PDF herunterladen (Seite 11)

1: Introducing the 8x8 AES Nodes • 3

Version 2.0, February, 2007

surges. Standard line surge protectors can be

used to offer some degree of protection. It is

the user’s responsibility to ensure protection

adequate for their conditions is provided. This

equipment is designed to be operated from a

power source, which includes a third “ground-

ing” connection in addition to the power leads.

Do not defeat this safety feature. In addition to

creating a potentially hazardous situation, de

feating this safety ground will prevent the in

ternal line noise ﬁlter from functioning. If fuse

replacement is required, please note: For con

tinued protection against ﬁre, replace fuse only

with same type and value. See the DETAILED

TECHNICAL INFORMATION section for informa

tion and cautions.

Livewire (100 Base-T) Connector

This connector is for connection to another Livewire

node, or an approved Ethernet switch. It has two integral

LEDs. The green “Link” LED indicates the presence of

a live signal (same as the front panel “Link” LED). The

“Activity” LED indicates that Ethernet packets are being

sent or received over the link.

IMPORTANT NOTE: Axia nodes are intended for

use with an Ethernet Switch that supports mul

ticast and QOS (Quality of Service). On a non-

switched Ethernet hub, or a switch that is not

enabled for multicast, this will result in network

congestion that could disrupt other network

activity. Should you wish to connect a node to

a non-Livewire network for access to the web

conﬁguration interface, etc, you must ﬁrst con

ﬁrm that streaming is disabled as described

in Section 2 page 6 “Programming the Node’s

Streaming Mode”.

Input Connectors

Each pair of audio inputs share a 8-position / 8-pin

miniature modular jack (e.g. RJ45 style). The connector

pin functions are the same for both the AES and Analog

nodes and are as follows:

IMPORTANT NOTE: Axia recommends using bal-

anced audio connections for analog audio con

nections. If unbalanced sources are to be con

nected to these inputs, we strongly recommend

using a balanced to unbalanced buffer ampliﬁer

(or transformer) at the source device. Such de-

vices are readily available, for example the Stu

dio Hub “Match Jack – Output”.

Analog Input Characteristics

Level: +4 dBu nom (+24 dBu clip point)

Impedance : >/= 10 K_

For additional technical information please see the

Speciﬁcations section.

Output Connectors

Each pair of audio outputs share a 8-position / 8 pin

miniature modular jack (e.g. RJ45 style). The connector

pin functions are the same for both the AES and Analog

nodes (see above).

INPUT CONNECTORS

Pin Function: Analog/AES

1 Left Channel Input + /AES +

2 Left Channel Input - /AES -

3 Right Channel Input +

4 Not Connected

5 Not Connected

6 Right Channel Input -

7 Not Connected

8 Not Connected

AES Input Characteristics AES3/EBU Compliant

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 34 35

Kommentare zu diesen Handbüchern

Keine Kommentare

Axia Analog Node Bedienungsanleitung Seite 11

Kommentare zu diesen Handbüchern